Traditionally, concrete block factories have been using production boards manufactured from softwood. Over the past decade, RHINO production boards for concrete blocks have revolutionised the concept of long lasting production boards. Instead of using softwood in manufacturing of production boards, RHINO uses FSC rated plantation hardwood, thereby increasing the density of the boards. These hardwood fires are then densified using extremely high-pressures and temperature to density of 1000 kg/cubic meter. Use of permanent bonding, synthetic thermosetting resin ensures extremely high resistance to moisture absorption during the lifespan of the pallet. To further improve the lifespan of the pallet, both surfaces are laminated with abrasion resistant substances, to make sure that production boards for Concrete Blocks last long in a very abrasive environment.

To further improve the strength of the production boards for concrete blocks, both surfaces are reinforced with steel mesh. The steel mesh ensures reinforcement of the pallet so that there is minimum deflection when load is applied to the production boards for concrete blocks. Deflection of the boards is a very important perimeter for production of quality blocks in the factory. The quality assurance system in any factory and Insurance that the concrete blocks have very strict dimensional accuracy. The use of steel mesh also insures that the vibrations are equally distributed to all paths of the pallet. This ensures that the concrete blocks all over the boards get almost equal vibration. This insures equal compaction of concrete blocks further, improving the quality of the production.

Ensure that there are no unnecessary damages to the corners of the Production-Boards for concrete blocks, all the boards are chamfered at the edges so that there are no sharp corners. All the corners of the board are cut at 45° angle so that any collisions with the steel conveyor do not result in any damage to the board. Rhino Production-Boards for concrete blocks. Do not necessarily need it steel edge. However, depending on the request by the client, steel edge can be riveted to 2 or four sides of the board. This further increases the strength of the pallet, reduces deflection and results in a overall increase in the lifespan of the Production board.